Welcome to the InES CT Board Wiki. On this page you'll find information about the CT Board and its components.
The InES CT Board is based on the STM32F429 Discovery kit from ST Microelectronics.

Documentation of the microcontroller STM32F42xxx: Data Sheet, Reference Manual and STM32 Cortex-M4 programming manual.

To install and configure Keil uVision for the InES CT Board start here.

CT Board Input
Simple input peripherals, reading from switches and buttons:
DIPSW, Buttons, HEXSW, GPIO

CT Board Output
Simple ouput peripherals, writing to LEDs and displays:
LEDs, 7 segment display, LCD, GPIO

Memory Bus
SRAM memory bus for external memory mapped peripherals:
External Memory Bus, Visualisation of External Memory Bus

Analog I/O
Converting from and to analog signals:
ADC, DAC

Digital I/O
Communication peripherals and simple I/O:
GPIO, EXTI, SPI, UART

Timer
Time / clock based peripherals:
Timer 2..5, SysTick, RTC

System
System configuration and control:
NVIC, RCC, PWR, DMA

InES HAL Documentation.

Accessing the registers using the defined data types.

Optionally packs for the STM32F4 microcontrollers can be installed from the ST Microelectronics Website

Please read our InES Coding Guidelines

Uncrustify Source Code Beautifier (software doesn't work properly at the moment).

If your project crossed the code size limitation of 32 Kbytes (mostly on MC1 Module) then you have to use a license.

Institute of Embedded Systems
ZHAW School of Engineering
Technikumstrasse 9
Postfach
8401 Winterthur

+41 58 934 75 25
info.ines@zhaw.ch