Differences

This shows you the differences between two versions of the page.

--- stm32:peripherals:timer_base [2022/12/27 17:46] – [Programming Example] ruan
+++ stm32:peripherals:timer_base [2023/10/19 09:49] (current) – frtt
@@ Line 2: / Line 2: @@
 \\ {{timer_base.svg}} \\ \\
-===== Programming Example =====
-The code snippet bellow shows how to configure and use a GPIO pin as input.
-<code c>
-#include "reg_stm32f4xx.h"
-RCC->APB1ENR |= (0x1 << 0u);          /* Enable TIM2 clock. */
-/* configure timer */
-TIM2->PSC = 84000u - 1u;              /* Counting with f = 84MHz / 84000 = 1kHz */
-TIM2->ARR = 512u;                     /* Count to 512 */
-TIM2->CR1 |= (0x1 << 0u);             /* Start timer */
-</code>
-\\
 ===== Configuration Registers =====
-==== CR1 ====
+==== TIMx_CR1 - Configuration register 1 ====
-Configuration register 1
 \\ {{timer_reg_cr1.svg}} \\ \\
@@ Line 36: / Line 17: @@
 |:::|1|Counter enabled|
 //*This bit is readonly in center-aligned or encoder mode// \\
-==== DIER ====
-DMA / Interrupt enable register
+==== TIMx_DIER - DMA / Interrupt enable register ====
 \\ {{timer_reg_dier.svg}} \\ \\
@@ Line 50: / Line 30: @@
 |:::|1|Update interrupt enabled|
-==== SMCR ====
+==== TIMx_SMCR - Slave mode control register ====
-Slave mode control register
 \\ {{timer_reg_smcr.svg}} \\ \\
@@ Line 76: / Line 54: @@
 |:::|011|Encoder mode 3|111|External clock mode 1|
-==== PSC ====
+==== TIMx_PSC - Prescaler register ====
-Prescaler register
 \\ {{timer_reg_psc.svg}} \\ \\
-==== ARR ====
+==== TIMx_ARR - Auto reload register ====
-Auto reload register
 \\ {{timer_reg_arr.svg}} \\ \\
@@ Line 90: / Line 64: @@
 ===== Data Registers =====
-==== CNT ====
+==== TIMx_CNT - Count register ====
-Count register
 \\ {{timer_reg_cnt.svg}} \\ \\
-===== Legend =====
+===== Programming Example =====
-\\ {{legende.svg}} \\ \\
+The code snippet below shows how to configure and use a timer.
+<code c>
+#include "reg_stm32f4xx.h"
+RCC->APB1ENR |= (0x1 << 0u);          /* Enable TIM2 clock. */
+/* configure timer */
+TIM2->PSC = 0u;              /* Counting with f = 84MHz / 1 = 84MHz */
+TIM2->ARR = 84000u - 1u;                     /* Count to 84000 */
+TIM2->CR1 |= (0x1 << 0u);             /* Start timer */
+</code>
+\\