Differences

This shows you the differences between two versions of the page.

--- software:start:uvision_on_mac_m-series [2022/12/28 09:06] – ruan
+++ software:start:uvision_on_mac_m-series [2025/02/05 14:39] (current) – removed frtt
@@ Line 1: / Line 1: @@
-====== Running Keil uVision on MAC M-Series ======
-  - Install Windows in Parallels. Parallels is currently the only (comfortable) way to run standard Windows on an M1 or M2 Mac. Parallels offers a lot of comfort by automatically downloading the appropriate installation image. Parallels is fee-based, but available for students for CHF 43.75 at www.studyhouse.ch.
-  - Install Keil uVision on Windows. The normal installer can be downloaded for this.
-  - Install the ARM64 driver for STlink:
-    - Download the driver here: https://community.st.com/s/question/0D53W000011vaXZSAY/stlink-stcubeprogrammer-support-on-windows-arm64
-    - The driver is not signed. Therefore, the signature check of Windows must be deactivated before installation. To do this, start in Recovery Mode:
-    - In Windows, open the input field via Windows-R and enter "shutdown /r /o". This will start Windows in Recovery Mode.
-    - Deactivate the signature check according to instructions number 3 at: https://appuals.com/how-to-fix-the-third-party-inf-doesnt-contain-digital-signature-information/
-    - Unzip the driver package and then install the three files "stlink_dbg_winusb.inf", "stlink_VCP.inf" and "stlink_bridge_winusb.inf" by right-clicking and selecting "Install".
-  - Check in the Windows device manager whether the STlink is recognised. The CT board must be connected to the Parallels VM for this.