Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| software:start:uvision_on_mac_m-series [2022/12/28 09:00] – ruan | software:start:uvision_on_mac_m-series [2025/02/05 14:39] (current) – removed frtt | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ===== Running Keil uVision on MAC M-Series ===== | ||
| - | |||
| - | - Install Windows in Parallels. Parallels is currently the only (comfortable) way to run standard Windows on an M1 or M2 Mac. Parallels offers a lot of comfort by automatically downloading the appropriate installation image. Parallels is fee-based, but available for students for CHF 43.75 at www.studyhouse.ch. | ||
| - | 2. Install Keil uVision on Windows. The normal installer can be downloaded for this. | ||
| - | 3. Install the ARM64 driver for STlink: | ||
| - | 3.1 Download the driver here: https:// | ||
| - | 3.2 The driver is not signed. Therefore, the signature check of Windows must be deactivated before installation. To do this, start in Recovery Mode: | ||
| - | 3.3 In Windows, open the input field via Windows-R and enter " | ||
| - | 3.4 Deactivate the signature check according to instructions number 3 at: https:// | ||
| - | 3.5 Unzip the driver package and then install the three files " | ||
| - | 4. Check in the Windows device manager whether the STlink is recognised. The CT board must be connected to the Parallels VM for this. | ||