Differences

This shows you the differences between two versions of the page.

--- software:start:ct_board_test [2023/09/08 07:26] – frtt
+++ software:start:ct_board_test [2023/09/08 07:38] (current) – frtt
@@ Line 11: / Line 11: @@
 ===== 4) Test procedure =====
-{{:getting_started:ct_board_test.jpg?600|}}
+{{:getting_started:ct_board_test.jpg?1000|}}
 === 4.1) LCD Background Light ===
@@ Line 17: / Line 17: @@
 The background light of the LCD should cycle through the colours: red, green and blue
 </WRAP>
+<WRAP clear></WRAP>
 === 4.2) Button & 7 Segment Display ===
@@ Line 76: / Line 77: @@
 === 4.6) GPIO Ports P5/P6 ===
-This test require a flat ribbon cable, which you will find in the laboratory.
 <WRAP col1 box round 1000px left>
+<color #ed1c24>REQUIRES ADDITIONAL HARDWARE!</color> This test requires flat ribbon cable,\\
+which you will find in the laboratory. Skip this test if you do not have access to it.
 <WRAP 400px column>
   - {{:getting_started:lcd_status.png?400|}}\\ The status of the port is displayed on the LCD.\\
@@ Line 87: / Line 89: @@
 === 4.7) 7 GPIO Ports 1..4 ===
-This test require a flat ribbon cable, which you will find in the laboratory.
 <WRAP col1 box round 1000px left>
+<color #ed1c24>OPTIONAL:</color> This test requires additional hardware.\\
+Skip this test if you do not have access to it.
 <WRAP 400px left>
   - {{:ctboard:ctboard_mode_1.svg?50|}}\\ Please make sure the CT-Board is in the correct mode. Supported modes: 1