Differences

This shows you the differences between two versions of the page.

--- software:keil:uvision [2020/02/07 12:18] – akdi
+++ software:keil:uvision [2025/09/16 08:11] (current) – [1) Download & Install] ovel
@@ Line 4: / Line 4: @@
 The light version of the software is available for free, but is limited to 32 KB (size of compiled binary). \\ \\
-> Dowload Keil uVision from [[https://www.keil.com/arm/demo/eval/arm.htm|www.keil.com]]
+**Windows operating system**
+> Download Keil uVision from [[https://www.keil.com/arm/demo/eval/arm.htm|www.keil.com]]
+> During setup, make sure to set the destination folders to **C:\Keil** for the Core and **C:\Arm** for the Pack in the folder selection.
+**Mac operating system (no support)**
+> Download and install Keil uVision for [[MacOS_M-series]].
+**Linux operating Systems (inofficial solution, no support)**
+> Download and install Keil uVision {{software:keil:install_manual_linux.pdf}} \\ \\
 ===== 2) Add Software Pack for CT Board =====
@@ Line 11: / Line 18: @@
 For the CT Board there is a special pack which has to be installed seperatly. \\
-> Download current [[https://ennis.zhaw.ch/pack/InES.CTBoard14_DFP.4.0.2.pack|InES uVision Pack]]
+> Download current [[https://ennis.zhaw.ch/pack/InES.CTBoard14_DFP.4.0.4.pack|InES uVision Pack]]
 ===== 3) Install ST-Link Driver =====
@@ Line 21: / Line 28: @@
 Location of ST-Link Driver:
-> For 64 bit Architecture: //C:\Keil_v5\ARM\STLink\USBDriver\dpinst_amd64.exe//
+> For 64 bit Architecture: //C:\Keil\ARM\STLink\USBDriver\dpinst_amd64.exe//
-> For 32 bit Architecture: //C:\Keil_v5\ARM\STLink\USBDriver\dpinst_x86.exe// // //
+> For 32 bit Architecture: //C:\Keil\ARM\STLink\USBDriver\dpinst_x86.exe//
+\\ \\ \\ \\
-**Back to [[software:start:getting_started|Getting Started]]**
+//**Back to [[software:start:getting_started|Getting Started]]**//