Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
ctboard:peripherals:analog [2016/02/11 06:44] – feurctboard:peripherals:analog [2016/02/25 10:53] (current) – [Programming Example] feur
Line 3: Line 3:
 The Potentiometer is directly connected to the STM32F429ZI microcontroller on [[stm32:peripherals:adc|ADC3 channel 4]]. \\ \\ The Potentiometer is directly connected to the STM32F429ZI microcontroller on [[stm32:peripherals:adc|ADC3 channel 4]]. \\ \\
  
-> {{ctboard_mode_no.svg?48px }} This functionality is independent of the CT Board mode. +> {{ctboard:ctboard_mode_no.svg?48px }} This functionality is independent of the CT Board mode. 
-> Supported modes: Available in all [[mode_switch|modes]]. +> Supported modes: Available in all [[ctboard:mode_switch|modes]].  
 +\\ 
 + 
 +==== Programming Example ==== 
 + 
 +To configure and use the potentiometer, setup [[stm32:peripherals:adc|ADC]] on the microcontroller. \\ \\
  
 ===== Diagram ===== ===== Diagram =====
  
 \\ {{:ctboard:peripherals:ctboard_analog.svg?700em}} \\ \\ \\ {{:ctboard:peripherals:ctboard_analog.svg?700em}} \\ \\
  • ctboard/peripherals/analog.1455173064.txt.gz
  • Last modified: 2016/02/11 06:44
  • by feur