Differences

This shows you the differences between two versions of the page.

--- ctboard:peripherals:analog [2016/01/26 12:04] – created feur
+++ ctboard:peripherals:analog [2016/02/25 10:53] (current) – [Programming Example] feur
@@ Line 1: / Line 1: @@
 ====== Potentiometer ======
-On the CT Board are 32 DIP switches mounted. They are arranged in 4 groups of 8 DIP switches. \\
+The Potentiometer is directly connected to the STM32F429ZI microcontroller on [[stm32:peripherals:adc|ADC3 channel 4]]. \\ \\
-If a DIP switch is in the position "high" (see [[#diagram]] below) it provides a logical **"1"**. \\ \\
-> {{ctboard_mode_1.svg?48px }} {{ctboard_mode_2.svg?48px }} {{ctboard_mode_3.svg?48px }} Please make sure the CT Board is in the correct mode.
+> {{ctboard:ctboard_mode_no.svg?48px }} This functionality is independent of the CT Board mode.
-> Supported modes: **1**, **2**, **3**
+> Supported modes: Available in all [[ctboard:mode_switch|modes]].
+\\
-===== Registers =====
+==== Programming Example ====
-The Registers are read only.
+To configure and use the potentiometer, setup [[stm32:peripherals:adc|ADC]] on the microcontroller. \\ \\
-|< 100% 10em >|
-^  Address  ^  Bit 7  ^  Bit 6  ^  Bit 5  ^  Bit 4  ^  Bit 3  ^  Bit 2  ^  Bit 1  ^  Bit 0  ^
-^  0x6000'0200  |  S7  |  S6  |  S5  |  S4  |  S3  |  S2  |  S1  |  S0  |
-^  0x6000'0201  |  S15  |  S14  |  S13  |  S12  |  S11  |  S10  |  S9  |  S8  |
-^  0x6000'0202  |  S23  |  S22  |  S21  |  S20  |  S19  |  S18  |  S17  |  S16  |
-^  0x6000'0203  |  S31  |  S30  |  S29  |  S28  |  S27  |  S26  |  S25  |  S24  |
 ===== Diagram =====
-\\ {{:ctboard:peripherals:ctboard_dipsw.svg?800em}} \\ \\
+\\ {{:ctboard:peripherals:ctboard_analog.svg?700em}} \\ \\