Differences

This shows you the differences between two versions of the page.

--- ctboard:peripherals:7segment_raw [2016/06/08 11:08] – [7 Segment Raw Interface] feur
+++ ctboard:peripherals:7segment_raw [2022/12/23 11:08] (current) – ruan
@@ Line 1: / Line 1: @@
-====== 7 Segment Raw Interface ======
+====== 7-Segment Display - Segment Control Mode ======
-This is the "raw" interface. Each segment of the display can be controled independently. The segments are **"active-low"**, e.g. the segment is on if a logical "0" is written to it. \\ \\
+Each segment of the display can be controlled independently. The segments are **"active-low"**, e.g. the segment is on if a logic "0" is written to it. \\ \\
 > {{ctboard:ctboard_mode_1.svg?48px }} {{ctboard:ctboard_mode_2.svg?48px }} {{ctboard:ctboard_mode_3.svg?48px }} {{ctboard:ctboard_mode_4.svg?48px }} Please make sure the CT Board is in the correct mode.
 > Supported [[ctboard:mode_switch|modes]]: **1**, **2**, **3**, **4**
 \\
+===== Registers =====
+The registers are read / write.
+\\ {{ctboard_7seg_raw_reg.svg}} \\ \\
+===== Diagram =====
+\\ {{ctboard_7seg_raw.svg?700em}} \\ \\
 ===== Programming Example =====
-The code snippet bellow shows how to use the 7 segment display in segment control mode.
+The code snippet below shows how to use the 7-segment display in segment control mode.
 <code c>
@@ Line 30: / Line 40: @@
 \\
-===== Registers =====
-The Registers are read / write.
-\\ {{ctboard_7seg_raw_reg.svg}} \\ \\
-===== Diagram =====
-\\ {{ctboard_7seg_raw.svg?700em}} \\ \\